Installation instructions • Read online or download PDF • Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual. Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual – Download. Rockwell Automation IF8 Compact IF8 Analog. The Compact I/O modules can be used with a CompactLogix controller, IF4FXOF2F. IF8. IF16C. IF16V. IR6. IT6.
| Author: | Kinris Brajas |
| Country: | Haiti |
| Language: | English (Spanish) |
| Genre: | Music |
| Published (Last): | 9 July 2005 |
| Pages: | 69 |
| PDF File Size: | 12.71 Mb |
| ePub File Size: | 2.12 Mb |
| ISBN: | 869-1-62219-897-9 |
| Downloads: | 63525 |
| Price: | Free* [*Free Regsitration Required] |
| Uploader: | Jukinos |
For More Inform ation Rockwell Automation Support Rockwell Automation provides technical information on the web to assist you in using our products.
Tell us about it. This lets you individually cancel each low process alarm latch.
Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual | Page 10 / 32
Host Controller Spacing for single-wide modules 35 mm 1. The same information applies to all channels.
To allow communication between the controller and module, move the bus lever fully to the left 4 until it clicks. Don’t see a manual you are looking for? NC Wiring for channels are identical.
Channel 0 and 1 Configuration Data Channel 0 and 1 configuration data is shown below. The terminals will accept a 6. In that case, graphical screens are provided by the programmer to simplify 1769-it8.
Rockwell Automation 1769-IF8 Compact 1769-IF8 Analog Input Module User Manual
Or point us to the URL where the manual is located. Your markings ID tag will be visible when the module door is closed. Lock the end cap bus terminator 6. Input Data File Word For each input module, slot x, words in the input data file contain the analog values of the inputs.
Tell us what’s missing.
What’s missing? Tell us about it.
11769-if8 manual failed to upload Approximate Shipping Weight with carton g 0. However, some systems, like the ADN DeviceNet Adapter, also allow the bits to be altered as part of the control program, using communication rungs. Locate holes every The terminal screws are non-captive.
Overall hole spacing tolerance: Route the wire under the terminal pressure plate. Attach an end cap terminator 5 to the last module in the system by using the tongue-and-groove slots as before. Use a power supply that matches the input transmitter specifications.
Use M4 or 8 panhead screws. The latches will momentarily open and lock into place. You can use the bare 1769-of8 or a spade lug. Mounting screws are required on every module.
Replacing a Single Modu le within a System Loosen the terminal screws to be wired. Remove the label from the door, mark the identification of each terminal with permanent ink, and slide the label back into the door.
Ensure it is locked firmly in place. Wire fragments that fall into a module could cause damage at power up.
